Paul Kovach

University of Pittsburgh
Latest in Product Development
Capacity Planning: 10 Essential Steps for Manufacturers
Sponsored
Capacity Planning: 10 Essential Steps for Manufacturers
September 10, 2025
Screenshot 2025 09 10 At 9 26 37 Am
Acid Reflux Implant Maker Ramps Production Ahead of Expected FDA Approval
September 10, 2025
Proposed autonomous air system rendering.
Lockheed Martin's Skunk Works, BAE Systems' FalconWorks Announce Strategic Collaboration
September 10, 2025
Amazon-Zoox robotaxis are beginning to give free rides through parts of Las Vegas as part of its driverless service's launch.
Amazon's Zoox Launches Robotaxi Service in Las Vegas
September 10, 2025
Related Stories
Scientists have proposed a graphene-based sensor that can 'sniff out' a single molecule of explosives.
Product Development
'Sniffer Plasmons' Could Detect Explosives
Crop analysis technology in wheat field trials at Earlham Institute.
Product Development
Project Promotes a Sustainable Bioeconomy
Ep138nowlogothumbnail 57b315ca1035f
Video
Russia's Laser Weapons
AI Work Instructions. Automated from Your CAD.
Sponsor Content
AI Work Instructions. Automated from Your CAD.
More from Paul Kovach
AI Work Instructions. Automated from Your CAD.
Sponsored
AI Work Instructions. Automated from Your CAD.
Automated work instructions with DFM, tribal knowledge capture, 3D animations, and shop floor analytics.
September 5, 2025
Dr. Andrew Bunger in his Benedum Hall lab with the newly installed compression frame he uses to simulate the high-stress environment deep inside the Earth.
Product Development
Look at Nature with Eye of an Engineer
How naturally occurring geological features can inspire new methods in petroleum engineering.
January 20, 2017
For larger internal lattice networks, if the open run of the lattice network is close to the maximum build span, the solid skinned top surface of the lattice network will risk an incomplete closure. Because of internal stresses generated during the build, these unconnected areas raise and in turn cause the recoating blade to strike them, which results in a failed build.
Product Development
Grant to Make 3D Printing More Efficient
The work should make it easier to compensate for residual distortion, residual stress, and post-machining requirements.
August 17, 2016